When designing a transmission adaptor plate for an Automatic Transmission 4r70w or A40DE or e40d to another engine, assuming that the machined surfaces are parallel withing the oem's factory tolerance, how much misalignemnt shaft center to shaft center is practial, tolerable, and typical?
Are...
Anyone have a legitimate bellhousing CAD drawing or techinical information on dowel pin locations and boltholes for these two engine/transmission bolt patterns.
I have hand measured both and reasonably accurately documented them, but an "official" measurement / pattern would be greatly...
Anyone have a listing of ford part numbers vs. water pump pulley diameter / offset / bolt pattern?
I want to overdrive the waterpump on my 71 429 to alleviate some slow idle cooling deficiencies.
Thanks
