We wanted to study the variation of a gusset/rib in a clamp. We tested a sample and it was bend out of shape for a load of 200lbs. I need to redesign the geometry to improve the load using FEA.
When i modelled the geometry , FEA has predicting the stress to cross the yeild stress at 10 lbs at...
I put a sheet of following dimensions on floor. Assume the material is glass.
1) thickness 1.2 mm diameter 2"
2) thickness 1.5 mm diameter 2"
3) thickness 1.8 mm diameter 2"
4) thickness 2 mm and diameter 2"
And I apply same compressive load on all these sheets
Let us assume that i transfer...
Hi all,
I need to rerate the Gear box product from strength point and tell our counter part, what torque does this gear box can with stand.
I understand GEAR boxes fail by wear and pitting and other means. My task is to tell what torque does this gear box can with stand. Once I give those...
Hi all,
So far, in my analysis carrier, I was redesigning components to a bench mark design using deflection or frequency as a critieria, But not for the stress values. Now, I need to find the highest torque a particular gear box can with stand. I understand , "Entire carriers are based on...
I posted this query in bearings section. I feel this is the right forum to post this query.
Hi all,
This is a general question.
When we heat a cylindrical bar, it expands in Length, Outer diameter and
Inner diameter.
Now i have two queries.
1) We press fit a sleeve bearing made of steel...
Hi all,
This is a general question.
When we heat a cylindrical bar, it expands in Length, Outer diameter and Inner diameter.
Now i have two queries.
1) We press fit a sleeve bearing made of steel with a tin babit coating on to an aluminum endshield. When this assembly is heated
will the ID...
