I am trying to animate a section view. I have read the other posts in the forum, and they didn't help me resolve the problem. I have created a separate part to make the cut and it does cut the assembly, however it doesn't animate the cut. Instead it completes the motion sequence and then, as...
I am trying to identify a fitting. It is on a filter housing and looks like a hygienic (tri-clamp) fitting, but the dimensions don't match anything. Any suggestions?
I am trying to identify the attached fitting. It looks like a hygienic (tri-clamp) fitting, but the dimensions are different. The i.d. appears to be 14mm. Can anyone identify this?
I have a customer who requires studs to meet SA-193 (Grade B7) , we currently use Monel 400. From what I've been able to find out this material is not SA-193, but does it exceed SA-193? And if so is it generally an acceptable practice to substitute a higher grade material for SA-193?
I recently had a customer send certs back to me saying that ASME required tensile and yield strengths to be listed in Mpa. Our certs vary by manufacturer some use mpa, some use ksi , psi, etc. My questions are: Is this correct? Is this a new requirement? or Is it just easier for them to do...
I recently came across a problem regarding material used in a pressure vessel. We have always used material specified to ASME SA249. Now I am being asked to supply material to SB691. Does this only apply to AL6XN material or to 316L also?
