We recently installed SW2009 SP2.0, when inserting a new Datum or Feature Control the extension line is thick line, and the Feature Control box has a thicker line on the last box has anyone else seen this with SW2009?
Terry
When I print my drawing the crosshatch solid does no show as solid fill, no hacthing at all.
The crosshatch solid shows on my solidworks drawing but not in print preview or after printing.
Anyone else seen this?
SW2007 sp4.0
Terry
In the past I have used SDRC-Ideas and was able to extract a part from a feature on a part.
Can this be done in solidworks? I have a feature sketched on a part that really should be a part reporting to an assy.
I know I could cut and paste the skecth and pick a plane.
Any suggestions?
Terry...
Anyone have any problems with daul dimensioning?
In my drawing the dim's are ".341 in" solidworks gives me "8.65 mm" also dim ".021 in" solidworks gives me .52 mm".
SW2006 SP4.1
Terry
My friend is an Engineering Manager looking to switch from ACAD 2006 to a Solid modeling package.
He is looking at Solidworks and Solid Edge.
What are your unbiased opinions Solidworks vs. Solid Edge?
I have a ~$prefix before my part number in the feature manager. Can you tell me what the ~$ means?
Solidworks 2006, SP01 (we will be updating service packs this week)
This is my first time using this forum, thanks in advance.
Tak55
