Search results for query: *

We currently extrude Nylon 6/6 into shapes ranging from .04 to .08 in thick. I am looking for a less costly substitute to the Nylon 6/6. The main characteristic needed is capabiity to withstand 250 deg F without melting. Any suggestions?

I need to use a MS21921-10J swivel nut/fitting in an assembly. I have not found a drawing or model for it to get the details from. Anyone know where I can find one? Thanks, Ed

I need to use a MS21921-10J fitting in an assembly. I have not found a drawing of it or a model to get the details from. Anyone know where I can get find it? Thanks, Ed

We have a number of commerical applications on legacy drawings that call for cad plating. I'd like to eliminate it across the board due to the environmental issues and related high costs. Looking for suggestions as to the best replacement plating while keeping cost down. Thanks, Ed

I recently heard of a company called Knovel that produces electronic engineering books and reseach databases. Anyone have experience with their products/services?

I had a garage floor poured recently. 4000#, 6" thick (except apron which is up to 12"), over 6" packed gravel base, vapor barrier in between. There is fiber reinforcement and a seal coat. I plan to put in a car lift and several cars. I am in upstate New York and the temperatures have ranged...

I am making some prototype parts for use in an aircraft wing actuator. We typically use 304SS. I have 303SS on hand and can get the parts faster if I use it. The components are small, less than 1 inch diameter, and basically house some bearings and other components. Not a lot of stress...

I am familiar with turbo chargers and belt driven superchargers, but recently read a little about electric-driven superchargers. They can run off batteries or an alterator. Anyone else know anything about them, or have experience with them?

Does anyone know how to put text on the OD of a cylinder shape? So far, I can only get it on flat surfaces. Thanks. Ed

I have an application that will use an Air Turbine Starter ATS18-3A. The spec sheet states "Pad and sline mate with MS 3326-2". I am looking for details of the MS 3326-2 spline. Anyone know where I can find it? Thanks.

I am looking for details on the detached type of starters used on some race cars. I'm interested in the connection to the engine and disconnecting once it starts. Anyone know where I can find info? Thanks.