Pressure vessel is designed at 900# and -46c/75c design temp @97 bar pressure.Shell material is 316L and 36mm thk.Calculated MDMT is -29c by PV ELITE softwear.No heat treatment applied on the material and as per ASME SECTION VIII DIV-2 there is no impact testing requirement.
Kindly advise me...
1.Kindly teach me regarding the welding joint detail for 36mm thk shell plate (316L) of 900 # vessel.
2.If the lifting lug is touching the capping of the welding joint b/w ellipsoidal head and shell of the vessel,than is it allowed to flush the capping to keep the lifting lug straight?Vessel is...
A piping is designed to connect from compressor discharge and buffer storage tank.In case of compressor shutdown this piping will supplly nitrogen gas(as an alternate arrangement)to the plant,from the discharge piping of the compressor.The tie-in point at the discharge piping has a noticeable...
What is the difference b/w u-PVC & c-PVC pipe? Can i use the c-PVC piping specs in u-PVC pipng for waste water service in a chemical plant?
Thanks and regards.
mechanical19k96@hotmail.com
If the pipe material is API 5LX52, X65 and sizes are ranging 48" to 90" and thickness 25 to 32mm.
Kindly guide me the pwht requirement in the above stated case.
Regards.
In PV ELITE "BASE RING DESIGN DATA" there is an option "USE AISI DESIGN METHOD".If i use this option with 46%(%applied to bolt area * bolt stress)then i got the reasonable gusset plate and top/bottom ring thickness of the 900# vessel.
Please advise the AISI DESIGN METHOD critaria.
Regards.
We are designing a feed gas separator 900# Where the client requirement is to make shell in to two by means of body flange.The pressure is 97 bar and the temp is 75c.Shell material is 316L,body flange is sized by A-516 Gr.70 with SS clading.All the above info. have been analyed in PV ELITE...
