I would like to know how I can work out bearing reactions ( radial and axial load) if I have a shaft to which a helical gear is attached, supported by bearings on either ends. If I apply a torque to one end of the shaft how do the bearings see the load assuming the gear is transmitting the...
This follows my post in thread378-147910 ( Interpreting a flow curve) . I would like to know how I can generate a system flow curve for a 4 channel parallel circuit. The pressure drops across the four parallel sections are assumed to be the same.
As explained in the above thread, I took one...
Hi, I have a question regarding flow curves of a series of cooling channels drilled into a thick cylinder. Water is pumped through the channels to cool the cylinder. I have theoretically calculated the flow curves for the cooling channels with different diameter holes. A sketch of the channels...
