HELP --- Is there a way to calculate the surface area of an assembly? For example I am assembling three layers - two flat plates of a different thichness that sandwich a layer of bricks. When I try to use Model Analysis the value the I get is the surface area of all three layers as if they were...
Please Help --- How do you remane a part that is used in many/many assemblies? A part was create as a dummy and used in many assemblies and now I want to keep it but, must rename it with a company part number. How do I do this without haveing all my assemblies failing looking for the dummy number.
I am trying to reset my dimensioning to look as follows --
25.001
24.999
[635.025]
[634.975]
The standard is --
25.001-24.999
[635.025-634.975]
Please help
John K.
I am trying to set my dimensions so that the dual dimensioning displays as stacked. See example below.
25.005
24.995
[635.127]
[634.848]
The standard display is -- see below
25.000-24.995
[635.127-634.848]
I am using Pro/E Wildfire 3.0
Please help...
I have made multiple simplified reps. of an assembly. I am looking for help in exploding just some of the simplified reps and not all for drawing creation.
If possible - please help.
John K.
I am trying to place Dia. dimensions on a drawing of a cross section view of a large torus. The overall dia. is 85". As mentioned I am just showing the cross section view but, want to show the overall dia. Its the one where the open end of the dimension has the double arrowheads.
Please help
Dad1
I am designing a large round fixture (85" dia.) In my drawing I am only showing the cross sectioned view of the part and the fixture. I want to show the outer and inner diameter on the drawing with the double arrow at one end.
Please help.
Dad1
I am creating sheet metal doors. I am flange bending the four sides then entending the walls up and out.
Is there a way to completly close the corners. Everything I try leaves a small hole at the corners.
I am using Pro/E Wildfire 2.0
John K.
I am using Pro/E 200i2 and have a question on making a radial hole pattern around a center hole. I am creating a center hole and then want to try to sketch four radial holes around it to mount a flange. I don't want to go back to the edge of the plate. How do I use the center hole as my main...
I would like some help in re-setting my Pro/E. I somehow hit a key stroke that changed my pointer from an arrow to what looks like a fist. How did I do this?? and How can I change it back??
My second question?? What is the easiest way to open assemblies when you need to pull parts in from multiple directories? As everybody knows --- the assemblies always fail.
