Hi all,
First of all, excuse me if this is not the correct forum where to post this thread, at least it has something to do with it.
I have to introduce a vessel's nozzle stiffness into the stress analysis software. I am using CAESAR II 4.50. I have radial displacement stiffness and...
Hi all,
First of all, excuse me if this is not the correct forum where to post this thread, at least it has something to do with it.
I have to introduce a vessel's nozzle stiffness into the stress analysis software. I am using CAESAR II 4.50. I have radial displacement stiffness and...
Hi all,
I'm with a pipe line (16'', CS) that serves steam to three vessels. I have done the stress analysis and everything is OK. But if I do a WRC107 analysis at the nozzles of the vessels, problems arise:
I have four hypothesis,
1. The three vessels operating, and so all hot.
2, 3 and 4...
Hi all,
I'm with a pipe line (16'', CS) that serves steam to three vessels. I have done the stress analysis and everything is OK. But if I do a WRC107 analysis at the nozzles of the vessels, problems arise:
I have four hypothesis,
1. The three vessels operating, and so all hot.
2, 3 and 4...
Hi all,
I am using CaesarII software to analyze stress on a steam piping system.
I am astonished because the results show forces on nodes where I am not putting restraints, and it also show displacements at this same nodes (and I'm not using gaps).
This is the first time I see something...
