Working on an impeller design and would like to determine the dynamic loads acting on the blades. I know the static load acting on the blade but the multiplying factor i'm getting to find the dynamic load is unreasonably high. Any help would be greatly appreciated. Ryan.
ps. I'm using...
hello all, I am designing an auger and I must compute the mass to obtain the resulting force. I cannot seem to find anything in my literature or on the internet about a calculation and was wondering if anyone had any insight or information? The formula would be as follows: m(total)=mass(inner...
Hello, I am designing a basic two-speed gearbox (high and Low) and was wondering if anyone new any good references or links in which I can find an exploded view or a general parts list of an existing model. I'm initially thinking of avoiding synchromesh and dogteeth as the gearbox does not need...
Hi, I posted this in agriculture but quickly realized that there hasn't been a post in two weeks. I thought it maybe better to seek help in this knowledgeable forum.
We're designing a tractor that will have a front mounted PTO and quick connect system and I am unclear on a couple of issues...
We're designing a tractor that will have a front mounted PTO and quick connect system and I am unclear on a couple of issues, any response would be greatly appreciated. I am trying to figure out what speed (rpm) the front PTO should run at, I understand that the standards for rear mounted PTO's...
