Is it possible to create a flat pattern from the attached file?
Using the forming/flattening set up I use for for straight bends, gives poor results.
So, I have been trying to use the other algorithms, but its trial and error and I don't seem to be able to get anything close.
I am using NX 5.0.6.3
Hello,
I am using sweep to create a closed loop slot in NX3, but the result is a random cut that goes on and off the part.
I am starting the sweep on the midpoint of a guide string and the part was modelled in an older version of UG. Both guide and section strings are full constrained.
Cheers...
