Hello,
I'm not sure if this is better suited to the mechanical or materials forums, but I'm way out of my league on the materials end and hope someone here has some experience with high-temp tensile testing of metal specimens (Inconel in this case.) I have to design a small furnace that can...
Hello,
I got a lot of good advice in response to my last question, so hopefully I can draw on someone's experience once again. I am looking for a DC gearmotor to drive an Acme lead screw. Due to space limitations, it cannot be colinear with the screw. I would prefer a right-angle DC gearmotor...
Hello,
I'm trying to find or build a small table-top tensile tester. Neither of the grips can be stationary-- both must move outward from a center point, i.e. driven by the same screw. It must also have load measurement. The specifications beyond this are not important, as it will serve as a...
