Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: xgrigorix
  • Content: Threads
  • Order by date
  1. xgrigorix

    Inferred Tolerance

    I have a component that is 123 +/-0.005 in width on witch there are some holes located on the centerline of part. Some are of the opinion that because these holes are shown on the centerline of the width with the applied tolerance, that the tolerance off of the centerline is +/-0.0025 There...
  2. xgrigorix

    Design Table & Threads

    I have a component which has a 1/4-20 UNC-2B thread running through it. I would like to set up a design table to drive multiple configurations. I cannot for the life of me get the table to drive the thread, too. Everything else comes in fine. Is this even possible? SW2006 SP5.1
  3. xgrigorix

    PDMWorks Enterprise

    My company is currently considering switching from SmarTeam to PDMWorks Enterprise (formerly Conisio) for our PDM. Any Solidworks users out there using Enterprise? Tell me what you can. What are it's strengths/weaknesses? Etc...
  4. xgrigorix

    ECO form

    Anybody have a generic ECO form that they are willing to share? I have been assigned the task of creating one, and of course would rather not do it at all (if I can help it). But, just in case no one has something generic that they are willing to share, I'll also accept suggestions for what...
  5. xgrigorix

    chamfer

    I have a cylindrical part with a chamfer at each end. Is the correct callout for this "2X 0.031 X 45°" or does each chamfer need to be noted individually? Thanks.

Part and Inventory Search

Back
Top