Hi,
We have an application that requires easy threading of a 4"
1/2 13 bolt into a 4" long coupling nut.
My problem is that every time I read the GH specs I find on the web, I can't tell which way the extra .0005" goes and/or whether it's a tap or die that is being discussed.
We're looking...
Hi,
I've got a timing application for a few sensor channels.
The circuit to monitor the event at each channel works fine, and I'm
thinking that if each channel could just send "some" data over the
serial lines, then a central PC could take care of all the
timestamping.
Is there a dirt simple...
Hi,
I've got hold of some samples of 65Mn stock (.050" thick) that seem
"almost" like stainless. I'm told in China it's considered a
cheap,tough steel good for a lot of applications requiring some
temper.
By this page http://www.castingsqd.com/products.htm it seems that 1065
is the closest...
Hi,
I'm designing a part with a size and complexity comparable to a
standard retractable utility knive. These knives seem to be diecast
from whitemetal (some alloy of Al,Zi,Mg) but my spec on surface
hardness is tougher than the samples I've tested.
This app is cost sensitive, and my reading...
Hello,
I have some carbon steel straps
(length=10" xsection: .06"x1.25")
that see some friction and some humidity (indoor environment).
Ideally, I'd like a wonder paint that is very tough, completely
rustproof and can't be scraped off, but that all seems mutually
exclusive. I could even see...
Hi,
All the design rules I've read on injection mold design suggest
maintaining uniform thickness to avoid sinking.
On my first design, I toiled for hours to get a uniform thickness
(within %10) , the mold house was happy and the prototypes came back
with all sorts of sinking. So the mold...
