Hello Eng-Tips Community,
I am in need of a dxf of a female JIS spline that will be cut with wire EDM. I attempted to reply to a similar thread but for some reason it was not working. Maybe the thread was so old that it was closed.
Here is what I have for spline specification (see jpg). Please...
Hello Eng-tips Gurus,
I should have wrote this prior to sending my parts in for heat treating and probably before bidding the job. I have a part to make that is machined from two pieces of 17-4 round stock. Part one is 1.63 dia x .38 long and Part 2 is .75 dia x 4.75. Part two is machined down...
Hi All,
I am looking for more information on main landing gear design, in particular, the practice of angling the mlg struts forward. I think it is common in many configurations but I am interested mostly in tricycle landing gear of small fighter jet size aircraft similar to F-5E.
Thanks,
Matt
I am using FEMAP/NX NASTRAN to model a composite wind turbine propeller. The primary goal is to optimize the twist of the propeller blades at given rotational velocity. I will be applying shear, moment and centrifugal loads statically while adjusting the layup accordingly.
I am new to FEMAP and...
