I'm looking to replace a few 6" pinch valves (one manual and one automated). The material being conveyed is nickel chips (approx. 17-25mm in diameter and approx. 3-5mm thick, density of 8.9g/cc @ 300K). The rubber internals are wearing out (gravity feed piping system @ 40 degrees off of a 80T...
I'm looking to replace a few 6" pinch valves (one manual and one automated). The material being conveyed is nickel chips (approx. 17-25mm in diameter and approx. 3-5mm thick, density of 8.9g/cc @ 300K). The rubber internals are wearing out (gravity feed piping system @ 40 degrees off of a 80T...
I'm in need of some assistance. We've been having trouble with our canned motor pumps for the past number of years.
Possible solutions at this point are mag-drive pumps, seal less pumps or displacement chambers. We've replaced the same canned pumps on another system with displacement...
