Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: fareng
  • Content: Threads
  • Order by date
  1. fareng

    Tabbing Parameters

    I am looking at tabbing parts into the skeleton as they are cut out to avoid tip ups. Dose any one have any good suggestions on tab sizing and lead in and lead out that should be used. We are cutting 16 gage to 3/8 inch mild steel. Thanks
  2. fareng

    Shrinking parts with dry ice

    I have seen dry ice used for shrinking fittings but I am not sure if I should use dry ice alone or with a liquid?
  3. fareng

    Efficient method of attaching/tightening hydraulic holes.

    I am redesigning at a process that uses open-ended wrenches to tighten hydraulic hoses. I have tried to use some ratcheting wrenches, however due to space issues this has had little success.
  4. fareng

    Help with a stuttering air cylinder

    I am designing basic manual lift using hydraulic cylinders with air as the power. It works pretty well but the cylinder stutters when it isn’t being run full throttle. So far I have tried to use an ail to oil reservoir to address this issue but I know that must be a better solution. Would a...

Part and Inventory Search

Back
Top Bottom