HELLO EVERYONE, I HAVE A TRICKY PART FOR TOOLING.
IT IS A DIAPHRAGM COMPONENT WITH A W/T OF 0.25mm.
ITS APPROX DIMENSIONS ARE 20mm SQUARE WITH A 2mm
HOLE THRO THE TOP FACE. THE SIDE AND TOP FACE ARE
A 3D FORM (MUCH LIKE A TEAT ON A BABIES BOTTLE BUT
IT HAS NO UNDERCUT). MY PROBLEM IS THAT THE...
I am thinking of moulding a PVC part, the grade is t.b.a.
I was wondering if anyone had any mould experience with PVC.
I was thinking of using pre-toughened stainless steel 1.2316
for the core & cavity plates as these appear to be good for a textured finish, as well as being resistant to the...
I have been given the job of quoting for new moulds.
Not very experienced in this and wondered if anyone can give me any advice/software that can help me in my quest for new work?
I have a tool to quote. It is basically a 22mm o/d tube , 6mm long with a flange to eject on at the bottom. It has a 1mm w/t. The problem I have is that it has a 0.4mm deep undercut ring all around the i/d. It is to be made from PEI - Ultem 1000. I dont have much experience with this and was...
I have to design an injection mould which moulds over a steel part. This is no problem except for the tolerance of the steel part. It is +.5, -.5. Any ideas how to soak up the tolerance in the tool?
