I have a question on how to do the following application with 2 servomotors that are being controlled from the same motion controller:
Imagine you have an elliptical shaped part rotating about an axis through it's center. This is being rotated at a constant velocity by servo #1. Then you have...
Having numerous 24VDC (rated @ 2A continuous) output cards that are going bad over the past year (a point or two will remain ON/OFF.) Cards are 3 years old. 16 point in 2 groups of 8 with. The outputs are 24VDC Solenoid Control valves (rated @ 1.25A with built in surge suppression). They...
We have a customer who has a 512 counts/rev (A A\ B B\) encoder mounted to a rotating shaft. They have a custom PC HMI application that expects to see 2048 counts/rev for position tracking purposes. This application can not be reconfigured.
Has anyone heard of an encoder signal multiplier...
If I have an industrial 24VDC incremental optical encoder with A and B channels in the field (say a dynapar/danaher encoder), how can I verify that it is working properly? Do I use an oscope and connect to the A and B channels to check that they are properly 90 degrees out of phase?
Anything...
I have a Phoenix Contact 24VDC Solid State Relay that I have a Sick Optic Photoeye wired to that is PNP. The contacts of the relay are switching 0VDC to the input of a PLC wired for sinking. The sensor is activating the relay transistor and is working fine. My issue is whether the Photoeye is...
