I am sure this topic has come up in the past but I did not find anything recent in the forum so I will ask for any help out there concerning how to render models in solidworks. Tutorials or help sites would work. I am using 06 solidworks.
Thanks
I am designing a reciprocating spray system and I was wondering if anybody knew of any material that advised the orientation of my spray guns or is this determined by prototyping and R&D specific to my application? I can post specifics if anybody would like me to such as linear speed, gun to...
Hello,
I have an application were I can use a static crush type seal or a static face seal and I was wondering if there was any thoughts of which type is better. I have been reading info on both and the only thought was that crush seals were intended for high pressure joints in hydraulics for...
Hello,
I would like to know if the design formulas for O-ring design parameters such as the glad dimensions, squeeze, extrusion gap, etc. vary greatly for pressure above 1500 psi. I have a joint that could see 3000psi. Also what are the benefits of a contoured backing ring verses a flat one...
Hello,
I am working on a compression seal joint that consists of two hollow shafts threaded together. The shaft with the female inner threads will be turning which will transmit torque to the other shaft (which has the male threads). The way I see it is I need to size both shafts to handle the...
Hello
I am trying to learn more about hydraulic spool valve center conditions. I am trying to find out what is the intended purpose for using a float type center condition spool valve.
