I have been asked to do some research on servo repairs, especially on remagnetizing a servo if needed. Can you guys give me any insight as to how it is done. What kind of equipment is required. What type of power are we looking at do this, etc...
thanks
I'm having a problem with getting a pcmk/a card to work with a plc2/16.
I followed the technote about modifying the config.sys file with no luck so far. I have tried the list of memory ranges listed by AB
Any help would be appriciated
We have been looking at the performance controllers from the Power Efficiency Corp. The controller is a soft start with an scr motor controller of sorts. My background is controls not motors so I'm not sure how to word my question.
I'm wondering can any damage be done to the motor by running...
We have 40F with a bad power supply board, it is a dc-dc ps
part number c-8730-1661-1
I am looking for some info on what a replacement board is worth, or possibly what the output current is for the +5V and +24V supplies and what I should be looking for from the PF output. Most of the components...
Is there a low cost controller that has an rs232 port with just a few i/o.
I have an application with a sick barcode reader. it has an
available rs232 port to send data to a pc. I would like to hook it to a cheap plc, send the data to the plc, decode the label data (up to four different labels)...
I have 6 presses that we are quoting a retrofit of.
The customer's needs are more than what the Omega system
offers so we are looking at the StamPro system as one possibility.
I would like to know the good, bad and uglies about the system. Any input is appreciated.
Thanks in advance
Has anyone here used the A-B Proset 200 or the
Siemens Siject 16? What are your thoughts on both units.
I have a couple of injection molding machines that need a
new controller and these take a lot of the programming work
out of the equation.
