I have heard mention of "EGR Anti-lag" systems being utilized on WRC rally cars, but I cannot find any details about how they work.
The only thing I have read is that they recirculate exhaust gasses back to the turbo manifold through a 'cat-like' device to burn residual fuel and increase...
I'm looking for a table of known density and viscosity values for water at temperatures from 25 to 80C in 5C intervals. If anyone has a resource, whether online or in a book, please let me know.
This makes sense in my head, but I just wanted to bounce it off you guys to make sure it's correct.
With a sliding caliper, the piston pushes the pad it is in direct contact with against the rotor. Then, once it's contacted, the caliper body slides until the other pad is in contact with the...
I'm an auto/mech engineer, and have only had a couple circuits classes, so please forgive me if I'm talking out of my you-know-what. But, easily-integrated 'green' power generation interests me, so here I am, trying to learn...
When a solar panel or wind turbine is added to a home, it's either...
My place of work has a large number of custom Matlab functions, but a lot of stuff gets rewritten just due to the fact that none of the individual programmers (myself included) really know what has already been done.
So...does anyone have a good solution for aggregating code? The only...
I'm wanting to design some control arms for a track day car, but I'm unsure of what to use for the loads for the FEA.
The advice I got was to use 4-3-2 as maximum load multipliers, and to assume the car corners at 1.5G's (higher than the actual).
My problem is that I don't know how to...
Hi, I am wanting to impose a displacement restriction on a slider joint, but am having no luck in doing so. I have tried all of the different motion drivers and modifying the limit and displacement values, but have not been successful. I have checked the UG documentation and have searched online...
