Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: SonnieTP
  • Content: Threads
  • Order by date
  1. SonnieTP

    Differerence in flow

    What could have cause this to differ in flow? Our waste water centrifugal pump is discharging water at a normal rate, there is an installed flow meter on the upstream of the waste water disposal approximately 15 feet away from the pump discharge and the flow rate is 225 gpm. On the downstream...
  2. SonnieTP

    Steam Blow

    Can someone explain the purpose of the target inserter that are used during steam blow? Are there any specific type of material to be used as a target inserter for steam blow?
  3. SonnieTP

    Pump Vibration Range

    What is the Hydraulic Institute acceptable vibration level for a 48” vertical pump that runs at 710 rpm and moves 60,000 gpm?
  4. SonnieTP

    Anti-Flash Valve

    I wanted to get information on what is the standard location to install the anti-flash valve on the boiler feed pump? Our boiler feed pump is equipped with an ARC valve connected directly on the discharge side. I am not sure if the ARC valve has an internal antiflash valve installed in it...
  5. SonnieTP

    Information about Piping code

    I have a Circulating water system that uses raw water on our facility. The P&ID shows an ID of "15 NB Sch 160"on some piping. Does anyone know what is "NB " stands for? I have look at the manual and system description but I have no luck on finding what it means.
  6. SonnieTP

    Maximum Allowable Working Pressure vs Design Pressure

    Does anyone has an experience on the HRSG design and configuration? The MAWP and the Desgn Press is the same on our Superheater and Drum section as well as the Reheater section of our HRSG. I ask the manufacturer why they did not place an allowance on both section and they quoted me the ASME...

Part and Inventory Search

Back
Top