Hi freinds
I am new to structural design field. Now i have to design a table with square tubes ,above these tubes, plate will be siiting which carries 100Kgs load & This plate carries a tensile force of 1900N at the edge
Now my question is ,how to bring assurence of my design,like how to...
Hi,
I need supplier details of Gear pump for the following spects
Rated discharge Pressure :3000Psi min,
Speed:8000rpm,
Flow:1-3GPM
thanks in advance
John
Hi ,
I am designing compound gear train for air RAM parachute system.Is there any website or any resource to get force analysis details of compound gear train
thanks in before
John
Hi Freinds
Due to space problem i used bearings as Phosperous Branze as bearing with gear shafts made up of Stainless steel 440C.Now de problem is there any electrolytic corrosion problem occur in feature years of functioning?.
Thanx in before
John
Hello,
i were badly looking for Maraging steel for one of my
aeropsace product.Can any one suggest me
maraging steel manufacturing or distrubuting
companies list around the world.
Thanx in before
John
Hi
how to get sectional view in model,so that i can get clear picture of model for further creation
& also if i take model into drafting mode,views created by
datum planes, how can i remove these planes,witout blanking these planes in model
thanks in before
John
Hi,
I were asked for Re-Engineering of Speed Control Governor Gear box..foe r four wheel Van
any good sites to get information about speed control governors
Thanks in before
John
Hi,
Most of DC Motors ,starts from speed from 1000pm onwards..
why cant we get 100rpm with 10Nm Torque capacity motors
any problem making such motors without gear head
Thanks in befor
John
Hi Freinds
We are asked for maching of size 600 X 400 x 9mm thick
AL60616T Grade,
To face need to me machined with flattnes 50microns,
problem is after machining,component getiing bend upto 1mm
any process to remove bend
Thax in before
John
Hi,
I were facing problem from DC motor which is open
in the system,above the motor RF cable is running,
so,due to EMI problem its affecting RF signals.
Now i planned to cover EMI shield over motor,so it may avoid problem sffecting RF signals
& i used Stainless steel,still the problem is not...
Hi
I need ,metal paste for alluminium to fill the cut outs.
And after pasting metal,i need to send it to for chromating.
Is there any metal paste which will not go after chromating.
thanx in before
Jhon
Hi Freinds
I know,in Hydraulics,most of aplication only energy transfer is there,& most of pnuematics is uses wit energy transfer takes place wit mass transfer.Is this correct
if so any other applications to differentiate clearly
thanx in before
John
Hi
I want to know what type of coating is done for aluminium parabolic reflector(Al alloy 6061)for maximum brightness and maximum reflectivity. At the focal point of the parabolic reflector a halogen bulb is placed.
Thanking you
John
Hi,
I have bought a CNC drill center from a second hand source in Singapore
with the following details:
Machine Model: TC211
Serial No : 111816
Machine : Drill Centre
Year of Mfg : 1985
Problem faced:
1)...
Hi
I am looking for a very low density material which has high thermal conductivity.
I have seen a imported low density microporous material , i am unable to identify the type of material.
Can u give me list of materials which meets above specification.
Thanking You
John
Hi,
i am planning to purchase UG Manufacturing software,
But, i am in confusion,in comparision of the other softwares,pleas provide me comparison of UG-Man,Master Cam& Pro-NC
Thanx in before
John
