I am a little stumped here. I have a part which we laser etch 3 small rectangles onto. The laser etching is called off of the centerline of the part, at 12 1/2 degrees 3 places. It has the true position box around it. The only tolerancing on the pads is a width of .120 +/- .020, and a box...
Just started a new job and they don't have any asme / ansi specs here! Anyone tell me what tolerance I have on a sharp corner callout per ANSI Y14.5M-1982?
Does anyone have any specifications on what lab conditions I would need to accurately measure to these tolerances? I have gotten a rejection from the customer in which our parts are .0013 to .0006MM undersize. This is a tolerance area I have never been in before and do not know if I can...
I have a part with a .125 diameter hole which breaks through and area it shouldn't. I need to do a weld repair on it and my customer needs a spec it will be done to. Any suggestions?
