Hi,
When I adjust the tol_text_height_factor in the .dtl nothing happens. It is my understanding that when I change this ration, the size of my tolerances in the plus-minus format should change accordingly relative to the dimension text size. Oddly enough the tol_text_width_factor seems to...
Two questions
1. Recently upgraded from wildfire 1.0 to 2.0. Looking at the metric unit systems available in 2.0 (CPS, MKS, mmNS & mmKS) it seems to me that mmKS is new to 2.0. Can anyone confirm??? I know longer have acess to 1.0.
2. With respect to the mmKS and mmNS systems does anyone...
I am measuring a large diameter of 100mm on a CMM. The tolerance on the interal diameter is extremely tight +/- 0.05mm. A lot of my measurements have had roundness values greater then the tolerance range > 0.1 which I have considered to be out of spec. Is this correct? Also, some have...
Hi,
I am measuring a large diameter of 100mm on a CMM. The tolerance on the interal diameter is extremely tight +/- 0.05mm. A lot of my measurements have had roundness values greater then the tolerance range > 0.1 which I have considered to be out of spec. Is this correct? Also, some have...
I am looking at new enclosures and encapsulants for some magnetic based motion sensors. The materials used are nonmagnetic. I am not quite sure how much of an affect, if at all, changing these materials would have on the sensors ability to pick up pulses generated outside the enclosure (ie...
