Hello everyone,
I'm a long time subscriber but infrequent poster. I've asked for help in the past and this forum has never let me down.
I have a 94 van dorn 170 ton, 14 oz molding machine with a Pathfinder EL control. This machine has been sitting idle for over 2 years but it needs to run...
Hello everyone. It's been a while since I posted here but I know where to get solid advice when I need it. :)
Does anyone know of company that offers repair parts for older injection molding machines? I have an old Cincinnati Milacron (1974) 250 ton Extended Platen machine that needs a new...
Hi Everyone:
I have inherited a mold that produces a tamper evident cap almost identical to those used in plastic milk/water jugs. The cap has a ring that sits below the cap body that must break away from the cap at 9 evenly divided points along the circumference when the cap is initially...
I don't hang out in this forum anywhere near enough as I should. This is great technical site. However, I do have a question that I'm hoping some of the more experienced mebers can answer. Keep in mind that I'm not a trained electrician; I'm more of general maintenace type of guy :)
I have...
Hello everyone:
I have a 60HP Delco-Remy AC motor that is about 30 years old. The shaft broke on one end due to the hydraulic pump seizing (which needs to be rebuilt). I have yet to take the motor end caps off, but I was wondering if the shaft slides inside an "armature sleeve" or does the...
