Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: AvusBlueM3
  • Content: Threads
  • Order by date
  1. AvusBlueM3

    8% Ni in PV in service less than -275degF

    Is there anywhere in the ASME Section VIII code which limits the use of 8% NI (SA553 Type II) to vessels in service temperatures higher than -275degF?
  2. AvusBlueM3

    Location Changes - ASME BPV VIII Div2

    Does NBIC or ASME address the requirements in which to change a location of a Division 2 vessel? The UDS and MDR both reference a specific location in which the vessel will be located (with applicable wind loads, loadings, etc). However I can not find anywhere which addresses the requirements...
  3. AvusBlueM3

    B31.1 / B31.3 Receving Inspections

    Hey guys, Is there anywhere in the code that states that all pressure bearing parts must have a Certificate of Conformance or a ANSI certification when received in order to build to either 31.1 or 31.3? Thanks for the help! ~Ryan QC Engineer
  4. AvusBlueM3

    Stress Relieving 9% NI, Tensile Properties

    Here's the situation. We cold form our heads for pressure vessels using 9% Ni plate (A553 and A353, mostly A553 though), and stress relieve the heads after forming. We closed a plant in Plaistow, NJ and inherited (paided for) a bunch of heads from that facility. Problem was, they didn't have...

Part and Inventory Search

Back
Top Bottom