I'am looking for a descent schematic for A 12VDC motor.
That can regulate the speed quit precise.
I would use PWM control but the schematics I found on the internet didn't do very good.
My motor can handle up to 16Amps, at least for one schematic that I found that was the problem.
It worked fine...
I have a hitachi L200 frequentie controller.
The L200 has an modbus output on RJ-45 connector.
I would like to control the L200 with a C++ program.
I bought a RS232/RS485 convertor to make the conversion between my PC and the modbus.But I'am unable to connect the L200 with my PC it just doesn't...
Does someone have experience with the UAA2016P chip?
I'am trying to regulte a shaded pole motor.
In the end it should be the meaning the control the speed of the motor in function of the temperature.
It would be a great help to have some feedback, it would be helpfull.Thx in advance
Hi
I'm looking for a circuit that can do:
control the fan RPM by the temperature,but with some conditions.
If the temperature is below 40°C then the motor doesn't have to run.
It needs to vary in speed between 30°C and 70°C by RPM
And above 70°C it needs to run at full speed.
The fan needs to...
Hi
I'm looking for a valve that can be controlled by a motor.
But the diameter of the valve should be 180mm.
The valve is used to control the flow.
The motor should be able to start and stop at any point along its way.
Does someone have any suggestions where I can find that?
