We have a John Zinc burner that needs to be replaced in 2 week lead time. Wondering if there are any other vendors that can do this.
45,000,000 btu/hr @10psi delta P
sp gr 0.72
95F gas temp
approx 4 foot length
thanks
I have a 1" OD aluminum tube w/ approx. .08" wall x 12" long, and I would like to insert some sort of well nut or rivet nut at the top of the tube. The tube is counterbored to allow room for the head of the nut. I have no experience with these so I was wondering if anyone could help me out...
HI
I'm looking for 3 feet of 2.5” SCH 40 pipe in any of the following materials with a 1-2 day ARO
Haynes HR-160
RA-330
RA-333
INCONEL 617
INCONEL 601
INCONEL 600
If anyone knows a place that stocks these please let me know. I'm calling all over the place.
Thanks
Our suction is 1" discharge is 2"
Right now our pump is designed for 30 gpm but we only need 2-4. Here's what we need
Flow: 2-4 gpm
Pressure: - 100 psi differential
Product: Jet fuel
Suction pressure available: 18 psi
Is this something I can buy off the shelf such as a simple ANSI pump?
Any...
I have a 10" drain hub with a 4" sitting approx 2" inside the drain hub. I need to contain the material going into the drain so I was hoping to find a simple pipe coupling to place over the OD of the pipe and drain hub. I found this site but they do not have the size. The product is 250...
Anyone know where I can find a 10" steel pipe cap similar to this? (second from bottom)
http://www.mcmaster.com/nav/enter.asp?pagenum=3546
I need to cover a 10" above ground drain (hub) and this seems to be the easiest alternative
Thanks
I am trying to inspect a 3/4-10 UNC-2B capnut for use with a 3/4-10 UNC-3A plain stud. The 2B cap nuts will thread on to the 3A studs that I have, but will not even begin to thread on to the 3B gage that I am using to check them. I figure that there must be a reason but I can't explain it...
