Does anyone know if you can use an array as an input variable when solving an equation using the Find function in Mathcad? I would like to output an array with corresponding solutions to the values in the input array. The same question was asked a while ago in this thread - thread552-245502...
Could somebody please suggest how to analyse a clip joining tubes together in a rack I'm trying to substantiate. The clip joins two tubes perpendicular to each other. One tube slides through the end of the clip and the other slides inside the clip. The attached image will hopefully explain more...
Can someone please confirm if I'm reading a drawing for a pressure tube correctly. The drawing consists of data for a Leonard tube bender. The following data is given:
length 17.5", dia 0.25", rad 0.75", Bend procedure R/H.
Bend, Dist from A, Bend, Dial
1, 15.063, 79, 0
2, 12.125, 85, 84
3...
I'm designing rack and pinion steering for a landing gear system and need some advice on gear tooth selection. Standard gear teeth proportions are unacceptable for stress reasons.
I'm working with a module 5 tooth on a 160mm PCD. I'm thinking of using an equivalent 20-degree American Standard...
