Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
ASME Section I, 2011 Addenda, Table PW-39-1 discrepancy?
I would like to have anothers opinion on the following: Table PW-39-1 GENERAL NOTES:(a)(1)and a)(2)make reference to paragraph PW-39.4 when I believe the paragraph should reference PW-39.3. See attached file for guidance... FAQ731-376 A question properly stated is a question half solved.- CodeRef
- Thread
- Replies: 4
- Forum: Boiler and Pressure Vessel engineering
-
PWHT Maximum Material Thickness ASME VIII-1
Am I correct to make the assumption that the intent of UCS-56(d)(1) through (5) term "maximum material thickness"is intended to reference the "governing material thickness" as defined in UW-40(f)(1) through (6)? FAQ731-376 A question properly stated is a question half solved.- CodeRef
- Thread
- Replies: 14
- Forum: Boiler and Pressure Vessel engineering
-
Thread Engagement Requirements
Background - the bonnet of a check valve is assembled by threading studs into the valve body and nuts on the exterior surface of the cover. Each nut has complete thread engagement. In this particular valve design, the hole for each stud projects through a edge of the valve body. Thus, it is...- CodeRef
- Thread
- Replies: 7
- Forum: Nuclear engineering
