Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Straight-sided Splines
I was wondering if anyone knew how much wear is acceptable on an 10T. External Straight-Sided Spline before a replacement is necessary. The Spline width was originally .540/.538" when new, I was wondering how much wear is acceptable. Is there a standard? The O.D. is 3.485" and the...- GEOR99
- Thread
- Replies: 3
- Forum: Gear and Pulley engineering
-
STRESS CALCULATIONS
I am trying to determine how to calculate if there is enough material between the bore of a gear and the root of the tooth. The gear is a 24T spur gear, the O.D. is 6.768", the pitch is 4DP(25pa), the bore is 4.250", the width is 4.63", and the RPM is 363. Does anyone know where...- GEOR99
- Thread
- Replies: 2
- Forum: Gear and Pulley engineering
