Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: kurtmcm
  • Content: Threads
  • Order by date
  1. kurtmcm

    Involute Spline tolerance and Classes

    I am reviewing an older Spline connection and have a question about the spline class and tolerance. These were done to ANSI-B92.2M-1980. Internal Spline: 2 Module 20 Tooth 30° pressure angle Class 2 Effective Clearances External Spline: 4H effective clearances I am not sure what Class 2...
  2. kurtmcm

    Involute Spline Maximum Effective Length. Le

    I am Looking for some Help with determining the Effective length of a spline but can not find a calculation anywhere. I have the Machinist Hand book Spline section and it has a chart but I seems like there should be a calculation for this. This is considered a Flexible Spline in the machinist...
  3. kurtmcm

    Press fit bushing, How do I calculate bushing ID after press fit

    I am trying to calculate how much a steel bushing that is press fit into a steel housing will shrink on the ID so that i can tolerance the shaft that goes through it properly. I have not had any luck finding this calculation. Thanks, Kurt

Part and Inventory Search

Back
Top Bottom