Hi all,
Apologies for this general forum question... I've searched the FAQs and elsewhere on Eng-Tips and can't find any information.
Does the "subscribe to forum" functionality, accessed from the top RH corner "Forums" tab --> "Subscribe to Forums" not work? I've tried it multiple times...
Morning all,
Hoping for some input/feedback on whether or not an orthogonal datum axis feature can be used to constrain the rotation of a primary datum axis. I can't find an example of this scenario in Y14.5-2009 or in any other online resources. The closest reference I could find was section...
Hello all,
Looking for some help with a problem that has me stumped...
I've got a rotary turntable that travels ±200° and I'm trying to locate inductive proximity switches and targets around the circumference of the turntable to provide CW and CCW limit signals. Ideally, I would like to...
Hello all,
I'm looking at the stresses generated in a hub due to press fitting on a shaft or due to an internal keyless locking assembly (such as from Ringfeder, B-Loc, Bikon etc).
I'm wondering if exceeding the yield strength of the hub material at the contact interface (i.e. hub ID/shaft OD)...
Hi all,
I'm having some difficulty reconciling the loading for the following scenario and was hoping for some help.
I have a Y-shaped structural member (looks like a tuning fork or motorcycle rear swingarm) with the "legs" of the Y rigidly attached to a rotating shaft. Overall length (or...
Hello all,
Hoping somebody can help me with this...
I'm trying to set-up .pcf files for a WF 3.0 installation and for some reason the plot_scale FIT_PAPER option is having no affect. I want to configure the .pcf so B, C and D-size drawings are scaled-down for printing on A or B-size paper.
I...
Hoping you can help me with a simple bolt load question.
I have a poured-concrete foundation wall covered with 2" rigid foam insulation (extruded polystyrene), and I need to secure a 4'x4' plywood panel to the wall. Approximately 250lbs of heating equipment will be mounted to the plywood...
Hoping you can help me with a simple bolt load question.
I have a poured-concrete foundation wall covered with 2" rigid foam insulation (extruded polystyrene), and I need to anchor a 4'x4' plywood panel to the wall. Approximately 250lbs of heating equipment will be mounted to the plywood...
