Is there anyway to delete multiple leaders in a note? (i.e. I have three, but only want two). I see its easy to create them, but see no way to easily delete them.
is there anyway to "save" the image quality? If I set the slider to high, then do anything to the part (i.e. zoom in or out) the image quality goes back to low.
The sheetmetal guys here are looking for a flat pattern that shows basically the tangent edges of each bend...I can give them the bend line, which appears to be the centerline of the bend...they can manually add the offset lines, but is there a way to get SW to show these?
SW 2005 SP3.1 -->...
I've created a few planes in an assembly, and I want to have a face of a component "X" distance away from the plane...if I enter the distance, SW says I've over defined it. If I let it ride (accept the default distance, rebuild), the "what's wrong" says "planar face and plane are not the correct...
Is there some way to turn off dimension previews? When creating a dimension, say between two lines, the previewed dimension value is shown at the cursor location, which often makes it difficult to make the second selection.
thanks!
