Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. willwoll100

    Lifting Shackle Stresses

    Hello All, I'm currently designing a lifting shackle to aid the recovery of a ROV, my problem is that I'd like to do some hand calculations to find the stresses in the shackle but I'm really not sure as to where to start. I know how to calculate the stresses in the fixing holes but it's the...
  2. willwoll100

    Engine Air Intake Flow

    Am I right in saying that when using dimensional analysis and using a 1/4 scale pipe for an air intake on a wind tunnel model that the mass flow rate will be exactly 1/4 of the full size when the air density, viscosity and velocity do not change? Regards Will
  3. willwoll100

    Creating surface from multiple point FARO arm scan

    Ok this is what I've got access to; CATIA V5 R12. Now what I need to do is change the multi point scan into surfaces, the file is currently in IGES format and I've imported it into CATIA but I really haven't got a clue as to how I go about changing the points into a surface. I've got around...
  4. willwoll100

    Calculating Torsion In A Chassis?

    Hello guys and gals I'm brand new to the forum and have question, here goes; I've done a torsion test on a car chassis with one end secured and the other end attached to a device which has a bar connected perpendicular to the chassis which rests on an arced section of steel on the floor. Now...

Part and Inventory Search

Back
Top