Dear Forum,
I am trying to calculate the different subsurface stresses over the depth for an elliptical contact area. I have formulas for a line contact and a point contact on a flat surface, but not the formulas for an elliptical contact, which should be the ones in a ball bearing. Can anybody...
Dear all,
I have to make a static spur gear calculation acc. to DIN 3990. In part 5 of this standard, diagrmms are available, which show the fatigue limit for pitting. Since I will have to calculate a static case, I am not sure if these values are appropriate for my calculation. E.g. for...
Dear Ansys users
when I want to get the path results from a straight edge in WB, I use the code snippet
/POST1
/show,png
/gfile,650
/RGB,INDEX,100,100,100,0
/RGB,INDEX,0,0,0,15
PATH,straigth,2,6,20
PPATH,1,,41.275,41.275,52.387,
PPATH,2,,41.275,41.275,68.263,
PDEF,straigth,U,X...
Hi,
in the MIl-HDBK -5H (or MMSPD01) is very often referred to the heat treatment handbook MIL-HDBK-6875.
As far as I know, this handbook is canceled. Can anybody provide a copy, can tell me where to get a copy or can tell me where to find the replacement?
Many thanks in advance.
Arnold
Hi folks,
I am currently benchmarking the wear beahavior of some different materials against a constant materials. As far as I understood, an important material property is the hardness. The hardness of the material which is used as wear partner is appr. 60 HRC. The material with the best...
I will start a benchmark between several FEM programs in our company next month. For some of the programs, I will use FEMAP as pre/post processor. What I have already found out, is that the material database is not in SI-units. The SI-units library is full of zero's. Since i would like to spend...
