Good Morning,
I've recently become immersed in a raging debate as to what has the largest influence on Tensile Strength of an extruded product (in this case PA6/6 on a 58mm twin). It has been my understanding that material porosity, resulting from inadequate devolitization and moisture...
We have recently experienced a motor failure which resulted in a full re-wind (bar stock) of the armature of a 400 hp DC motor. The motor manufacturer recommended the VPI process, however, that would have extended the repair by 48 hours (according to the service provider). We instead went with...
Good Morning,
I would like to ask a simple question, which will hopefully generate an equally simple answer. What link is needed to link a VB6.0 user interface with a PLC (specifically AB Micrologix Series C). I have heard of ActiveX DLL Drivers etc. but, as an Industrial programmer only, this...
I was wondering if anyone knows if / what relationship exists between wearing ZME (WP thermal mixing element) elements and the resulting tensile strength of a given product. Is it a gradual effect as seen with a single screw mixer, or is it immediate? We recently had an issue regarding a 50%...
