I have a project that requires me to design a high strength plastic part. My question has to do with if there should be any major difference in the way a glass filled acetal is injection molded versus an unfilled acetal. After trying 111P, 311P, and 511P acetals I was obtaining strengths...
I own a scale model jet turbine engine. To start this engine up I have to use a hair dryer to spin the engine up to 3000rpm's, then I can ignite the gas. I have seen small DC motors used for this step, connected directly to the shaft. I have heard that the motor can also act as a generator...
I am looking for information about this type of steel. From what I am told the only place it is made is in Japan and is very expensive. We use the material to make die cavities and we are looking to see if there is anyone in the US that makes it.
Thank you
