In the Dimension Text box for customising the dimension information, I would like to display the text "M4-6H EQUI SP PCD ø58" but for the ø58 I would like to select the dimension string D2@sketch8, So if the dimension changes it also changes on my drawing view.
I've tried placing the text...
I've been asked what I thought was a simple question until I had a go myself.
In 2D drawing format, I wish to attach a surface finish symbol to the outside dia of a shaft but show the symbol on the dimension line.
I can attach the symbol to the shaft edge but cannot constrain the symbol on the...
I am looking for some approximate guidelines for achievable tolerances from mumetal after heat treatment?
I have a design that will consist of cylinder 4" (101.6mm) in diameter, and 8" (203.2mm) in length rolled from 0.04" (1.02mm) thick mumetal sheet.
I am looking for comments as for what...
Can anybody help?
Are there any differences between black, brown or green viton flat seals. I have an application (Steam @ 140°C pressure 2.3bar - also vacuum at 100mbar) where I have validated the use of a 70 shore hardness Viton seals on some Solenoid valves. The seals were black in colour...
Can anybody help?
Are there any differences between black, brown or green viton flat seals. I have an application (Steam @ 140°C pressure 2.3bar) where I have validated the use of a 70 shore hardness Viton seals on some Solenoid valves. The seals were black in colour. Our production have been...
I am tring to conform to a specification that says the pipe fittings that we use must "be resistant to de-zincification if they are intended to come into contact with water" Brass fittings are our preferred choice for economic reasons.
To my knowledge all brass fittings that have a...
I need to review some historic fatigue assessment cyclic loading calculations can anybody suggest where the best place is to start?
Previous calculations were based on a total of 26,000 operating cycles. I need to review this for up to 36,000 operating cycles. It would be nice if I can agree...
