Hi, Can anyone advise me on where I can find information on standards for wiring identification protocol.
We are using a system at present which is quite complicated and I would like to see how common it really is.
The system comprises of a four digit component number and a couple of other...
We have recently changed our gas charge from R22 to 407. This is on a fairly small (15 kw) seawater cooled glycol chiller.
The system seems to struggle and with the seawater cooling side running less cold than it used to (32 degrees C seawater) we are having trouble getting the glycol really...
Hi all,
I have recently purchased an atomotive style a/c compressor for an emergency glycol chiller on a small boat.
It was sold as a 3kw output however on measuring we have only 1.6 kw. The engineers say it is working finem
My question is that in the spec it says operating speed 800 rpm -...
Can anyone tell me the common forging spec steel which would be used in the usa. It would be the equivalant of the british spec BS1503-224-490 LT50.This has a tensile of 500 - 650 n/mm2 and a yield of approx 350 n/mm2 .
I have been offered ASTM350 LF2 but its yield and tensile values are not as...
Can anyone tell me the common forging spec steel which would be used in the usa. It would be the equivalant of the british spec BS1503-224-490 LT50.This has a tensile of 500 - 650 n/mm2 and a yield of approx 350 n/mm2 .
I have been offered ASTM350 LF2 but its yield and tensile values are not as...
I am requiring some of the original certification of a vessel built to ASME / USCG . It does not have a nat board number on it and was built in early seventies. It does have a uscg number on it though. I called the NB but they told me that the builders did not start registring reports with them...
I am wishing to remove some local corrosion from the inside of a pressure vessel. Although it is quite deep, it does not go past the corrosion allowance.
I wish in a few months time to have the vessel gritblasted, however we require to leave the unit in service until that time.
Is there any...
Im hoping somebody can help out there. Im needing to make a very efficient and compact dehumidifier. We have only a small amount of air flow available, so im trying to select the correct type of coil. Ive been offered a type of coil which is like an oval or squashed type tube, aluminium...
We are looking at purchasing a vessel which has been constructed to an italian RINA code approx 20 years old.
We have found that it has a 2" nozzle which intersects the main circ weld from rolling to dished end.
Rina were not bothered but i am wondering where we would stand with ASME or even...
Just a simple question. Can anybody inform me what the max depth of cut normally allowed on a valve seat ? I have an engine and one of the seats is badly pitted in one very small area. Depth of pitting is approx 25 - 30 thou. Can i have this recut ? Engine is a diesel 4 litre 4 cylinder ford...
Tomorrow I need to drill approx 20 x 2 1/2" (63mm) diameter holes through the side of a 18" diameter steel pipe.
The holes are to take pins. I have thought of two ways to do this -
a) magnetic base type clamp on drill with a 2 1/2" cutter.
this would be the ideal way but the pipe grade is...
Hi, A few questions I hope can be answered. We have a U stamp vessel which needed some extra nozzles welded on. These were small 2" diameter 1" npt couplings.
We did the WPS, WPQR, WPQ etc. Got material certs for the couplings and involved Lloyds but only for the WPS / PQR.
We did...
