Search results for query: *

thread561-438421 Have two distinct parts on one sheet. The sheet is divide in half with Part 1 on the right and Part 2 on the left. On part 1, I create a Detail-A of a particular feature. And place the Detail-A in the area of part 1. For Part 2, I take a Detail of a feature on it and place it...

I recently ran into a situation where a designer had added 2 ears about .75 below the top surface of the cylinder to establish Datum Targets A1, A2, and A3 on the under side of the ears, B1 and B2 were on the ends of the ears (opposite sides), and C1 was placed on one side of the ear to...

tangent line, when appropriate and not.. drafting standards.

Question.. Has anyone ran across a 13mm Thread.. looking for the data if so. Thanks in advance.

What is the proper GD&T dimensioning/callout for drilled holes that are at an compound angle to datum "A" but you want the holes to be perpendicular to the sweeping contoured surface...

I am presently working for a Co. that is using a Source Control Drawing in a way I have never seen before. I have worked many years on DOD projects and question this process.. But cannot find a viable reason to defend against it. They are pasting the vendor’s part including the vendors drawing...