Hi,
What would be the best way to secure an electrical harness on high vibration components. I have tried using tie-straps and P-clips and everything seems to fail as the braid on the harness gets cut into and is cutting the insulation on the wires after some time.
Thanks
Nick
Hi,
Do we have any forums for checking what corporations do for all the jobs of engineering. I am specifically looking for strategies for contracting works, outsourcing, communication methodologies with outsourced or contracted works.
My corporate is using some external contractors for some...
Hi folks,
I am resigning from my current postion as I have got a much better position.
I just want to make sure this transition goes smooth. I have no any conflicts or complains with anyone and I need advise from all of you guys on this.
Do I need to take any letters of work experience with...
Hi folks,
I am a new engineer(just a couple of years of exp) and I am working in a company where practically there is no work for me to do for more than 3 months.
All I can do is to sit and wait for the work to be assigned to me by my immediate supervisor who is a good for nothing person.
I...
Hi folks,
I have a connector and I am looking for the replacement standard for the part in commercial or MIL spec standard, IEEE or any other non SAE standard.
The part numbeer is for a controller area network connector.
SAE J1939/11 (CAN connectors). It is a 3-pin connector plug.
Any info...
Hi all,
I have an SAE spec number for a connector and I am looking for any possible information regarding the connector(like MIL specs, IEEE codes etc).
Is there any interchange for this part available. If so where can I find the info regarding the interchange parts numbers.
The spec that I...
Hi,
I have a crankshaft which rotates with a 6000 rpm speed.
This crankshaft is driven by a motor and I have a setup where in the crankshaft is loaded both sides( motor in the center)
I have installed 2 bearings on each side to support the shaft. The ball bearings that I use are 12X24X6 on both...
Hi,
I have a crankshaft which rotates with a 6000 rpm speed.
This crankshaft is driven by a motor and I have a setup where in the crankshaft is loaded both sides( motor in the center)
I have installed 2 bearings on each side to support the shaft. The ball bearings that I use are 12X24X6 on both...
Hi all,
I need some advise on the sealing of a steam expander.
This expander is used in a power generation unit and it runs contiuously. It was running in a fair condition before and now suddenly there was a time when there was a sudden incerase in temperature of incoming steam cos of which...
Hi all,
Does anyone know how to include the path directory of the drawing file or part file in the drawing format table.
I mean just as we can include date and part file name in the format table.
Thanks for all the replies.
Cancsco
