I've looked at most everything I can think of for this application.A mixed gas by volume % of SO2:11.73, O2:11.73, CO2:0.14, N2:76.4. The pipe is 86" diameter, 10mm wall CS. Norm flow 78,000 Cu ft/hr, 150 deg F., upstream press -2PGIG. minimal up/downstream diameters too as per the attached...
We're about to replace qty 16 old magmeters with new ones. However the new ones have a shorter lay length leaving a 6.25" gap from old to new in our 20" lines. 55 PSIG water service, ambient temperature,
150# flanges.
Having custom spool pieces manufactured is looking expensive and standard...
A tough flow / totalizer application where waste water and grease is collected from restaurants and food processing. The flow is made up of grease trap waste with water at 3 to 5%, with food bits, sludge and grease up to 35% solids. It's the solids content that is the most critical.
All...
I am looking at replacing thermocouples with 4-20mA temperature transmitters and, instead of incurring the expense of re-wiring with regular copper analog shielded wiring, re-used the existing thermocouple extension wires?
Presently the thermocouples (close to 150) are hard wired back to...
Looking to have central indication of level points as measuremed by 3 Siemens/Milltronics LU10's (28 levels all together). It has AB remote I/O, PROFIBUS DP, Modbus RTU, and Devicenet capabilities. All I really need is central indication of all the level points, but do have a Windows network...
Our present practice to achieve the bath height is to attach a metal bar to the blowing lance. This bar is dipped into the bath and the remaining bar length is measured considering the lance position. The duration of this measurement is rather long and the measurement itself is relatively...
