Hello,
does anybody know how i can setup wire templates with two colors.
this is very common for harness wires, but i cannot find any documentation on this.
Thanks in advance for any help.
Klaus
Unigraphics NX Key user
it all started with V13
Hello,
we work with Catia, Creo and NX.
We can create list attributes in Creo and NX (see Screenshots).
Does someone know if something similar is possible in Catia?
Otherwise our users would enter the wrong (predetermined) values.
Thanks
Klaus
Unigraphics NX Key user
it all started with V13
Hello,
does somebody know how we could define Friction stir welding with the NX welding assistant?
It does not really add material but it still needs to be defined for drawing and simulation.
Best regards
Klaus
Unigraphics NX Key user
it all started with V13
Hello I just create a new title block.
And I have a problem with a number attribute.
It always shows six digits after the comma.
If I use the same text outside of a table it just show the necessary digits.
I also tried the style settings of the table but that does not influence shown attributes...
Hello,
I need the below shown draft of a tilted cylinder in NX (also attached NX part).
And the draft only needs to be added where necessary (not on all sides).
Currently this is done with a few features which are not really intuitive.
If I show this to our users I always get some frowns.
I...
Hello,
does anybody know if it is possible to setup the NX (8.5) drawing standards to show sheet and sector information for detail and section views?
Thanks
Unigraphics Key user
V13, V14, V15, V16, V17, V18, NX, NX2, NX3, NX4, NX5, NX6, NX7.5, NX8, NX8.5, NX9
Hello,
I worked at an OEM and they had a tool which suspended the Catia V5 session to save licenses.
All the parts (even not saved ones) where cached and the session could be restored by the push of a button.
Does anybody knows now if there is an commercially tool available to do this or if...
Hello,
we use Vismockup to generate clearance checks and I have a question regarding the results.
When the check is started there are usually many false errors which are not relevant for example bolts.
In Vismockup the status of the error can be switched to not relevant but I cannot find the...
Hello,
I configured our companies check mate profile and also included a layer check to see if all objects are on the designated layers.
This worked perfectly until now but NX9 also checks the sketch constraints and gives an error during the check.
The problem is that you define in the checker...
Hello,
I`m just setting up a new working environment for our company in NX8.5.
My question/problem is that since NX8 during the creation of a base view NX takes now the master model as basis.
And then the new standard is that it doesn't even create a component in the assembly navigator (found...
Hello,
my problem is that the wall thickness check from the molded part validation is not feasible for complicated cast parts like a cylinder head.
The first problem is that even if if you filter the check results (and also use very small tolerances for the check) the checker always shows sharp...
