Anyone else have issues with the hole wizard propagating to the components? In the assembly without propagating it works perfectly. As soon as I set it to propagate, the holes move into random locations even though they are fully defined in a 3D sketch in the assembly.
Can anyone point me to a specification or requirement for temperature and humidity control of inspection specifically for aluminum parts for the aerospace industry. We are primarily non-commercial which means that FAA requirements may not apply. If there are FAA requirements I would definitely...
Fairly often when I have a model edge I want to pull into a 3DSketch using the Convert Entities feature, on closing the sketch I receive the following warning message:
"The sketch has not been updated because it contains conflicting model references which are due to the topological changes in...
I am looking for a .010" thick silver or copper plating on a 4" cube pin heatsink. I have contacted a number of plating houses and was told that electroplating and electroforming of this geometry was impossible. I am hoping to find an electroless plating solution. I know I can use Electroless...
