Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Convert Dimensions Macro
Sorry folks, this is a repeat questiosn, but I've spent a half hour looking for the information and can't find it. I was using a macro that converted all dimenisons in a part / drawing / assembly from inches to mm. (or vice versa) We just converted to SW 2007 and got new computers. Very...- ejc
- Thread
- Replies: 1
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Dimension Anchor Points
Since I switched to 2006 (running SP1), I can not move the anchor points of the dimenison's extenstion line. Is this new in this release, or am I missing a simple setting? The dimensions come in anchored off my view, and I can not move them to look right. I can create a reference dimension in...- ejc
- Thread
- Replies: 5
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Water Vapor in Bearing Cavity
When specifying seals for bearings, I have come across these claims. When bearings start, they increase temperature, resulting in a build up of pressure in the bearing chamber. This is usually expelled through the vent, or through the seal. When bearings stop, the heat dissipates, resulting...- ejc
- Thread
- Replies: 11
- Forum: Bearing design, manufacture and maintenance
