I am trying to figure out the nailing schedule to combine two treated fir 2"x10"x16' boards together. Application is for three of these 2' feet apart, total of 4' wide for an ATV bridge spanning 12' allowing for 2' supported portion on each end. So far, the best I can come up with is use a...
Hi folks,
I am looking to take a position at a consulting office. It's a small office and my compensation is based on a salary if I hit a certain amount of billable hours worked for the month. If I can get past that minimum monthly threshold, I can earn about another 30% for every...
Hi Folks,
Can you help me with definitions of the following engineering department titles, and what the "industry standard" meanings might be? The industry is in Mechanical Design, Product Design/Consumer Products.
Product Development Engineering
(Product Development Engineer)
Applications...
I have an aluminum extrusion part that I designed and I am looking for the industry standard that deals with the following:
surface gouges
surface marks
scratches
dimples
other "dents"
I am looking for a spec. (ASTM?, Mil-spec) that defines the industry standard for the above list for an...
Hi,
I am looking for a conductive coating for Aluminum. So far, I have come up with electroless nickel plating, but have found it to be VERY expensive. Are there any other solutions out there that meet WEE and ROHS requirements?
TIA,
Justin
