Dear All,
We can set our own shortcuts to any commands using customise option. when I move to some other system, I dont want to set the shortcuts again. I just want to transfer the existing setpu.
Can anybody tell me, where the Keyboard shortcuts are getting stored?
Warm Regards,
Visu
Hello all,
I have created a survace in Catia V5 using "Multi-section surface". The splines that I have used are of order 5. Now I want to know what is the continuty of the surface.
What is the command that I have to use to check the order and continuty of a curves and surfaces. Any help would...
Hello all,
Is there any function/method to extract the number of dimensions required to make a sketch fully constrained? I have been trying at various sites and could n't make it. I could frame a small formula and that will provide the same. but it hardly depends on modellers own practice...
Dear All,
I need a quick help.
I'm working with IDEAS 9m2 simulation. In one of my project - I need to apply the pressure on to the particular model. The pressure data is available the txt format. there are around 928 points for a particular surface.
The input format is like this:
x...
Dear All,
I need a quick help.
I'm working with IDEAS 9m2 simulation. In one of my project I need to apply the pressure on to the particular model. The pressure data is available the txt format. there are around 928 points for a particular surface. the format is like this:
x y z p
x1 y1 z1 p1...
Hello all,
I have some problem with User Functions on "flat pattern". Any Open Ug Expert is here?
My problem:
I'm using the "uf_smd_create_flat_pattern" in my program. While executing the function in Ug it is almost generating the flat patter(99%) then it gives...
